Testing the mo.unit

It is not possible to measure the outputs of the mo.unit with a voltmeter, since the mo.unit uses semiconductor technology. Therefore, the outputs will always read a certain amount of voltage.
To test the outputs, please use any load such as indicators.

Device doesn’t power on:

+12V cable of the battery to BAT and Ground cable of the battery to GND.
The LED’s of the mo.unit should flash now for approx. 2-3 seconds.
After the flashing stops, Connect 12v+ to the LOCK input of the mo.unit.
The LED’s should now show a round-robin, and then the IGNITION output LED should light up.
If the test was successful, connect all the in- and outputs and check their functionality.

Hold down the horn and switch on the ignition. (If that doesn’t work try switching on the ignition and press the horn 3 times within 1 second after switching on)
Hold down Start and Horn until all LED’s switch off.
The mo.unit will now reset itself and recalibrate all outputs.

Install the newest version of the mo.ride app from Google-Play or App-Store on your smartphone.
Create a new mo.ride account and add/create a new motorcycle to your garage.
Hold down the horn and switch on the ignition. (If that doesn’t work try switching on the ignition and press the horn 3 times within 1 second after switching on)
Hold down the Start button for 10 seconds until the LED’s starting a round robin.
Now you should be able to connect to the mo.unit via app.
The mo.unit should be visible and able to connect.
--> If you can’t connect, please repeat the steps and follow the hints in the app.