How can I use the mo.button and a kill switch?

When you use a mo.button, no KILL switch can be used at the KILL input.

The function of the "Kill" switch is replaced by double-clicking the start button.

If the original KILL switch should still be used, the following solution might work.

An opener is needed, which closes the circuit in position "ON". The KILL switch interrupts the power supply of the ignition or ignition coil when it is activated. The switch is connected between the IGNITION output of the mo.unit and the positive pole of the ignition coil.

This solution only works with transistorized ignition.

Did this answer your question? Thanks for the feedback There was a problem submitting your feedback. Please try again later.