mo.unit - Light switch

To switch the light between low and high beam on the mo.unit the original switching unit or a push button can be used.

When the engine is started, the low beam is switched on automatically.
A ground signal must be sent to input LIGHT to activate high beam.
A switch to switch the light on or off is not needed. If a push button is used, the light can be switched on and off by pressing and holding it.

Problem:

• Light switches off after 2 seconds

In this case, the key control is probably configured incorrectly.

• Light does not go off

Switching off the light is only possible with buttons.

In case of further problems, the motogadget support team should be contacted.