motoscope tiny, vintage, speedster - Control lamps defective
The control lamps must be connected as described in the operating instructions, some require a plus signal and some a minus signal.
To test the inputs for their functionality, the blue, white, purple and yellow cable must be disconnected from the wiring harness.
- Switch on the motoscope (connect red and brown cable to +12V and black cable to ground)
The motoscope should now perform the function test by moving the pointer to 200 and back to 0.
Now test all inputs individually:
- For the high beam indicator light hold the blue cable to +12V.
- For the neutral control lamp hold the white cable to ground.
- For the warning lamp, hold the purple cable to ground.
- For the turn signal lamp, connect the yellow cable to +12V.
If a lamp does not light up during the test, the input or the LED of the motoscope may be defective. In this case please contact the motogadget support team.
Problems:
Main beam indicator lamp glows when main beam is switched off
- Ground contact at the illuminant (H4 bulb) insufficient
- Contact resistance e.g. at plug contacts too high