motoscope - ignition signal pickup

In case of a capacitor discharge ignition (Some manufacturers call their digital ignitions CDI, although these are not capacitor ignitions.) an ignition signal pickup is needed to determine the speed. This can be found on the respective product page, tab Accessories of the motoscope or under the article number: 9000001.

The ignition signal pickup is attached to the ignition cable between the spark plug and ignition coil. The function depends strongly on the signal quality of the ignition. Therefore, the function can not be guaranteed.


Install the ignition signal pickup as follows:

Did this answer your question? Thanks for the feedback There was a problem submitting your feedback. Please try again later.