mo.relay+ - Function

The mo.relay+ is a flasher relay with integrated button control. Depending on the duration of actuation of the respective flashing button, 4 modes can be called up. The mo.relay+ requires push buttons as operating elements, latching switches are not possible.

It is possible to switch between 1W and 100W, the device is therefore load independent.
When using only one blinker light, diodes have to be connected between them to prevent all 4 indicators from flashing at the same time.

Problems
Flashing frequency decreases continuously until the light is permanently on:
This could be due to an underload, it is recommended to install power resistors to artificially increase the load.

Did this answer your question? Thanks for the feedback There was a problem submitting your feedback. Please try again later.