mo.blaze - mounting

 For proper use of the mo.blaze flashers a 12V DC power supply and a suitable flasher relay is required. 6V vehicle electrical systems are not supported.

mo.blaze disc & cone:
For the handlebar end turn signals at least 4cm space in the steering tube is required, there must be no thread or other things in the way. The inner diameter of the steering tube should be between 14mm and 21mm. In addition a hole must be drilled into the handlebars to lead the cables out of the handlebars. Before installing you should check if and where this is allowed to place a hole.

mo.blaze pin, edge & ice:
For the mounting lights you need a hole with a diameter of 8 - 8,5mm.

To use the mo.blaze disc and mo.view bar end mirror at the same time we have adapters like the bar adapter uni disc cone, bar adapter BWM M12 disc or bar adapter BMW M10 disc.
Please check if there is enough space in the steering tube or if the right thread is available.

When converting from OEM flasher to LED flasher, it can happen that the flashing frequency is no longer correct. This is because the flasher unit probably expects a different load. If possible either the flasher relay must be exchanged or power resistors must be installed parallel to the flasher. Please refer to the article "mo.blaze - Power Resistors" for detailed instructions on how to determine and install them correctly.